Replacing The Filterbag; When To Change The Dust Compartment Filter (Pre-Motor Filter); Replacing The Dust Compartment Filter (Pre-Motor Filter); When To Replace The Airclean Exhaust Filter - Miele Classic C1 Instructions D'utilisation

Replacing the FilterBag (see fig. 18 +
19)
a Pull the plug from the socket
b Open the dust compartment lid and
raise until it clicks into place.
The FilterBag has a closing flap which
closes automatically when the dust
compartment lid is raised to prevent
any dust from escaping.
a Grasp the finger grip and pull the
FilterBag out of the holder.
b Insert the new FilterBag as far as it
will go into the FilterBag holder. Do
not unfold the FilterBag when taking
it out of the box.
^ Unfold the FilterBag in the dust
compartment.
^ Close the dust compartment lid until
it clicks into place. Take care not to
jam the FilterBag in the lid.
,
An empty-operation-barrier
blocks the dust compartment lid
from closing if no FilterBag is
inserted. Do not force it closed.
When to change the dust
compartment filter (Pre-motor filter)
Change the filter each time you open a
new box of genuine Miele FilterBags. A
dust compartment filter is supplied with
each box.
Replacing the dust compartment
filter (Pre-motor filter) (see fig. 20)
^ Open the dust compartment lid.
^ Open the filter frame, remove the old
filter, and insert a new filter.
^ Close the filter frame.
^ Close the dust compartment lid.
When to replace the AirClean
exhaust filter
Each time a new box of Miele FilterBags
is opened, this filter should be changed.
A new Air Clean exhaust filter is included
in every box of Miele FilterBags.
Replacing the AirClean filter (see fig.
21)
Do not use more than one filter at a
time.
^ Open the dust compartment lid.
a Open the filter frame until it clicks,
grasp the clean corner (see arrow)
and remove the used filter.
b Insert the new filter.
^ Close the filter frame.
^ Close the dust compartment lid.

Exchanging exhaust filters

Depending on the model, there may
also be an Active AirClean 30 or a
HEPA AirClean 30 exhaust filter
included which can be used instead of
the standard AirClean exhaust filter.
In order to use the Active AirClean 30
or the HEPA AirClean 30 filter the
AirClean filter and filter frame must be
removed. The exhaust filter change in-
dicator must also be activated (see fig.
22).
After about 10-15 seconds, a small red
marker will appear in the left-hand side
of the display (see fig. 23).
en
17