Before Using The Vacuum Cleaner; Using The Powerbrush - Miele Classic C1 Instructions D'utilisation

en
The illustrations referred to in the text
are shown on the fold-out pages at the
end of these operating instructions.
Before using the vacuum
cleaner
Connecting the Electro hose (see fig. 1)
a Insert the elbow into the suction
socket until it clicks into place.
b Insert the plug into the socket on the
inside of the carrying handle.
Disconnecting the Electro hose
c Remove the plug from the socket.
d Press the two release buttons at the
sides of the elbow and lift the hose
from the socket.
Connecting the hand piece and the
Electro Telescopic wand (see fig. 2)
a Insert the hand piece into the electro
telescopic wand until it clicks into
place. Use the inlet guides to direct
insertion.
b To release the hand piece from the
telescopic wand press the locking
button (see arrow) and pull the hand
piece away from the telescopic
wand.
12

Using the Powerbrush

Observe the cleaning instructions of
the floor manufacturer.
The Powerbrush is particularly suitable
for cleaning and restoring crushed
carpet pile of wall to wall carpeting and
floor coverings subject to hard wear,
especially in high traffic areas.
The Powerbrush can also be used on
smooth floor surfaces.
Do not use the powerbrush on:
– (SEB 217-3 only) Floors with a
variable or uneven surface. The
brush could come into contact with
the floor and cause damage.
– High quality, hand knotted rugs, for
example Berber or Persian rugs, as
well as extremely long piled area
rugs and carpets. There is a danger
of the threads being pulled out. Turn
the Powerbrush off to vacuum these
types of floor coverings and use only
suction.
Connecting the Powerbrush to the
Electro Telescopic wand (see fig. 3)
a Insert the Electro Telescopic wand
into the Powerbrush until it clicks into
place.
b To release the parts, press the lock
release button and pull the wand up
and out.
For more information on use and care
please refer to the instructions supplied
with the Powerbrush.