Before Using The Vacuum Cleaner - Miele S 5001 Instructions D'utilisation

en
The illustrations referred to in the text
are shown on the fold-out pages at the
end of these operating instructions.
Before using the vacuum
cleaner
Attaching the suction hose (see fig. 1)
^ Insert the elbow into the suction
socket until it clicks. Use the inlet
guides to direct insertion.
Removing the suction hose (see fig. 2)
^ Press the release buttons at the sides
of the elbow and lift the hose from the
socket.
Connecting the suction hose and
handpiece (see fig. 3)
Depending on the model, the handpiece
is already pre-fitted at the other end of
the hose at the factory. If the handpiece
of your model is separate, it just needs
to be connected to the hose.
^ Insert the hose into the handpiece
until it clicks into place.
Connecting the handpiece and the
telescopic wand (see fig. 4)
^ Insert the handpiece into the
telescopic wand until it clicks. Use
the inlet guides to direct insertion.
^ To release the handpiece from the te-
lescopic wand press the locking but-
ton (see arrow) and pull the handpie-
ce away from the telescopic wand.
10
Adjusting the telescopic wand (see
fig. 5)
One section of the telescopic wand is
fitted inside the other and can be
adjusted to your height for comfortable
vacuum cleaning.
^ Press the telescopic wand release
button (see arrow) to release the
tubes and adjust to the required
height.
Attaching the standard floor brush
(see fig. 6)
(depending on model)
Observe the cleaning instructions of
the floor manufacturer.
^ Insert the telescopic wand into the
floor brush and turn in either direction
until it locks with a click.
^ To release the floor brush from the
telescopic wand, press the locking
button (see arrow) and pull the wand
out of the floor brush.
The floor brush is suitable for cleaning
carpets, rugs, and hard surfaces. For
flooring susceptible to scratches, use
one of the special Miele floor brushes
(see "Optional accessories").
Adjusting the floor brush (see fig. 7)
Observe the cleaning instructions of
the floor manufacturer.
For vacuuming carpets and rugs:
^ Press the foot switch marked ö.
For vacuuming smooth floors:
^ Press the foot switch marked ä