When To Change The Thread Catcher Pads Of The Standard Floor Brush; Replacing The Thread Catchers; Cleaning And Care - Miele S 6000 Instructions D'utilisation

The ActiveAirClean 50 filter can be
used instead of the HEPA AirClean 50
filter and vice versa without any
changes.
When to change the thread catcher
pads of the standard floor brush
(depending on model)
The thread catcher pads on the bottom
of the standard floor brush (depending
on model) should be checked
occasionally. Replace the pads if they
appear worn.
Replacing the thread catchers (see
fig. 35 + 36)
^ Use a screwdriver or similar object to
remove the thread catchers from the
slots.
^ Insert the new thread catchers.
Cleaning the floor roller (see fig. 37)
(not possible with the AirTeQ SBD 650-3
Standard floor brush or FiberTeQ SBD
470-3)
a Unlock the roller pin with a coin.
b Push the pin out and remove it.
c Remove the roller.
^ Remove any threads and hair from
the roller.
^ Replace roller in the reverse order.

Cleaning and care

,
Turn off the vacuum and unplug
it from the outlet before performing
any maintenance work.
Vacuum cleaner with textile surface
Clean the surface with the dust brush
accessory or a damp cloth.
Vacuum cleaner and accessories
The vacuum cleaner and other plastic
accessories can be cleaned with a
damp cloth or a cleaner suitable for
plastics.
,
Do not use abrasive, glass or all
purpose cleaners, or oil-based
conditioning agents! They will
damage the surface.
Dust compartment
The dust compartment can, if
necessary, be cleaned using a dry
cloth, dusting brush or a second
vacuum to remove any dust.
Monitor the airflow indicator and
inspect all filters regularly. Clean or
replace them when necessary
according to these Operating
Instructions.
,
Do not submerge the vacuum in
water. If moisture gets into the
appliance there is the risk of an
electric shock.
en
17