Replacing One Type Of Exhaust Filter With Another; Maintenance Indicator With Reset Button; When To Change The Battery In The Radio-Operated Handle - Miele S 8310 Mode D'emploi

en
If you wish to use an Air Clean filter,
see "Replacing one type of exhaust
filter with another".
^ Close the dust compartment lid.
Replacing one type of exhaust filter
with another
Depending on model, your vacuum
cleaner will be fitted as standard with one
of the following exhaust filters (dia. 9):
a Air Clean
b ActiveAirClean 50 (black)
c HEPA AirClean 50 (white)
Please note:
1. If you wish to replace the Air Clean
filter a with an ActiveAirClean 50 filter b
or an HEPA AirClean 50 filter c, it is
essential that you remove the filter grille
before fitting the new type of filter (dia.
39). Press the reset button ~ for the
exhaust filter change indicator (dia. 12).
2. If you wish to replace the ActiveAir-
Clean 50 filter b or the HEPA AirClean
50 filter c with an Air Clean filter a, then
it is essential that you also fit the filter
grille *, see dia. 37.
* Filter grille - see "Optional accesso-
ries".
Do not use more than one exhaust
filter at a time.
46
Maintenance indicator with reset
button (dia. 40)
Some models are fitted with a
maintenance indicator.
The indicator lights up after approx.
50 hours of operation, which is
equivalent to about a year of average
use. The level of soiling of the dust
compartment filter and the exhaust filter
must be checked at this point and if the
filters are replaced, the indicator must
be reset. To do this the vacuum cleaner
must be switched on.
^ Press the reset button.
The maintenance indicator and reset
button will go out and reset to zero.
The indicator can only be reset by
pressing the reset button after the
light has come on. Pressing the
button at any other time will have no
effect.
When to change the battery in the
radio-operated handle
Approx. every 18 months. One 3 V
battery (CR 2032) is required.
The vacuum cleaner can still be
used when the battery has run out or
if there is no battery fitted.
^ Switch the vacuum cleaner on using
the On/Off foot control s. The
Stand-by indicator - on the vacuum
cleaner will light up yellow.
^ Press the restart button on the
vacuum cleaner (dia. 41).
The vacuum cleaner can continue to be
used, but only at maximum power.