Replacing One Type Of Exhaust Filter With Another; Maintenance Indicator With Reset Button; When To Replace The Battery In The Radio-Control Handle - Miele SG Série Mode D'emploi

 Close the dust compartment lid.
Replacing one type of exhaust filter
with another (Fig. 08)
Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters:
a AirClean
b AirClean Plus 50 (light blue)
c Silence AirClean 50 (grey)
d Active AirClean 50 (black)
e HEPA AirClean 50 (white)
Do not use more than one exhaust
filter at a time.
When changing the filter, please note
1. If you wish to replace exhaust filter a
with filter b, c, d or e, it is essential
that you remove the filter grille before
you fit the new exhaust filter.
If you are using exhaust filter c, d or
e, you must also activate the
timestrip® filter change indicator
(Fig. 11).
2. If you wish to replace exhaust filter b,
c, d or e with filter a, it is essential
that you also fit the filter grille* (Fig.
39).
* Filter grille – see "Optional ac-
cessories"
Maintenance indicator with reset but-
ton (Fig. 42)
Some models are fitted with a mainten-
ance indicator.
The indicator lights up after approxim-
ately 50 hours of operation, which is
equivalent to about a year of average
use. The level of soiling of the motor
protection filter and the exhaust filter
must be checked at this point.
The indicator must be reset each time
the filters are replaced. The vacuum
cleaner must be switched on to do this.
 Press the reset button.
The maintenance indicator will go out
and reset to zero.
The indicator can only be reset by
pressing the reset button after the light
has come on. Pressing the button at
any other time will have no effect.
When to replace the battery in the ra-
dio-control handle
Change the battery approximately every
18 months. One 3 V battery (CR 2032)
is required.
The vacuum cleaner can still be used
when the battery has run out or if
there is no battery fitted.
 Switch the vacuum cleaner on using
the On/Off footswitch  (Fig. 24).
The standby indicator  on the vacuum
cleaner will light up yellow.
 Press the restart button on the va-
cuum cleaner (Fig. 43).
The vacuum cleaner can continue to be
used, but only at maximum suction
power.
en
55