Replacing One Type Of Exhaust Filter With Another (Fig. 02); When Changing The Filter Type, Please Note; Service Indicator With Reset Button; Removing Threads And Hair From The Powerbrush - Miele HS08 Instructions D'utilisation

If you wish to install an AirClean ex-
haust filter, see "Replacing one type
of exhaust filter with another".
 Close the exhaust filter compartment
lid.
Replacing one type of exhaust filter
with another (Fig. 02)
Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters :
a AirClean
b Active AirClean 30 (black)
c HEPA AirClean 30 (white)
Do not use more than one exhaust fil-
ter at a time.
When changing the filter type, please
note:
1. If you wish to replace exhaust filter a
with filter b or c, you must com-
pletely remove the filter frame before
you install the new exhaust filter.
In addition, you must also activate
the exhaust filter change indicator
(Fig. 05).
2. If you wish to replace exhaust filter b
or c with filter a, you must insert the
new filter into a filter frame * before
installing(Fig. 29).
* Filter frame - see "Optional acces-
sories."

Service indicator with Reset button

(Fig. 32)
(on models with + / - buttons)
The indicator lights up after approx. 50
hours of operation, which is equivalent
to about a year of average use.
At this point, the level of soiling of the
dust compartment filter and the exhaust
filter must be checked.
The indicator will need to be reset each
time these items are replaced. The vac-
uum cleaner must be switched off to do
this.
 Press the Reset button.
The service indicator will go out and re-
set to zero.
The indicator can only be reset by
pressing the Reset button after the
light has come on. Pressing the but-
ton at any other time will have no ef-
fect.
Removing threads and hair from the
Powerbrush
 Switch the Powerbrush and vacuum
cleaner off. Unplug the power cord
from the electrical outlet.
 Release the vacuum cleaner (Fig. 11)
and lay it flat on the floor.
 Turn the vacuum cleaner over.
 Use scissors to cut any threads or
hairs which have become wound
around the roller brush. There is a
groove on the roller to guide you (Fig.
33).
Then, run the vacuum cleaner to vac-
uum up the cut pieces.
The bottom of the suction hose can be
accessed to remove heavy dirt or
blockages. Any large particles inside
the hose can then be easily removed.
en-US
21