Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3 - Installation
3.2 - Connecting the battery
Connect the battery to its connector, minding the polarities shown inside the housing.
Before connecting, make sure the slide switch is in OFF position.
3.3 - Tamper device
The Control unit should be protected against attempts at tampering by installing device item
6831 64 on the back.
To mount the tamper device remove the protection plug from the Control unit turning it by 90°.
If the flush-mounted box is flush fitted in the wall, before inserting the rod in the housing, cut it
at the first notch as shown in the figure.
Insert the rod, lock it by turning it by 90° and extract it completely.
52mm
< 60mm
97
Publicité
Chapitres
Table des Matières
