5 - Programming
•
level 2
(installer) allows access to all menus, apart from the modification of the user code.
The installer can access the level only:
From the keypad
Press OK then type the Maintenance Code (basic 00000)
The Maintenance Code does not enable/disable the system;
if the system is enabled, it will not allow access to the menus.
Note: in the setups made at the factory, user codes and maintenance codes coincide and are
both: 00000; in this case, access is available for all programming menus; to change the main-
tenance code, see par. 6.9.
115