Event Memory - LEGRAND 675 20 Notice D'installation

6 - Burglar-alarm menu
Scenarios

6.4 - Event memory

Refer to this menu to display the last 200 events recorded by the burglar alarm system. It is also
possible to know the type of event (see table of events in par. 8.4), the date and hour of recording.
Also, in case of an alarm, you can find out which sensor produced the alarm.
For consultation convenience, the events are shown in chronological order, starting from the
most recent one.
Recording date and hour
Sensor that has detected
It is possible to display all stored events one after the other with the
It's possible to display other information on the event with the key
Erasing the event memory (possible only with installer's code)
The installer can erase the entire event memory with the following procedure:
11/11/08 11:37
Intrusion alarm
120
Zones Devices
of the event
the event
Event: 035
C1 central
Erase?
OK confirm
CLEAR cancel
ATTENTION
erasing
event memory
Date and hour Automations
Event: 035
11/11/08 11:37
Intrusion alarm
C1 central
Press the
The page on the left appears.
Press the pushbutton to erase
erasing menu
Press
Settings
Progressive number
Type of recorded event
(see table of events sec. 8.4)
keys.
.
key
to erase memory
Maintenance
from the