LEGRAND 675 20 Notice D'installation page 145

8 - Operation
This table allows fast identification of the meaning of each stored event that is displayed through
the menu Event memory.
Displayed message
INTRUSION ALARM
ANTIPANIC ALARM
SILENT ALARM
TAMPER ALARM
SILENCING
BATTERY BROKEN
BATTERY OK
BUS SCS ON
BUS SCS OFF
SUPPLY LACKING
SUPPLY RETURN
PSTN MISSING
PSTN PRESENT
DIVISION
CODE REQUEST
INSERTION
DISCONNECTION
TECHNICAL START
TECHNICAL END
TECHINCAL RESET
Intrusion alarm produced by a detector
Alarm forcing both when system is on and off )
Alarm that activates the telephone call only
Tampering alarm (both for unit and other devices)
The alarm has been stopped
The system battery is dead, Vbat < 10,4V
The system battery has been recharged correctly
Voltage return of the SCS bus
Voltage failure to the SCS bus
Power line voltage failure
Return of power line voltage
The PSTN telephone line is missing
The PSTN telephone line has been reinstated
Variation of status of one or more zones
A connector has requested a code check to the unit
The system has been enabled
The system has been disabled
A technical alarm went on
A technical alarm has ended
A technical alarm has been reset
Type of event
145