LEGRAND 675 20 Notice D'installation page 113

5 - Programming
Firmware update
This function allows updating the Unit software with its latest release. Such update allows bringing
in improvements as well as new Unit functions.
The latest firmware releases are available at www.legrandelectric.com
Before starting the fi rmware updating procedure position the slide switch on OFF
For further information, see SecurityConfig software manual.
Programming of parameters
This section of the program allows complete editing of each parameter of the Unit with remarkable
simplicity.
It is possible to receive the existing configuration from the Unit, change it and send all changes to
the Unit (in this step, the software executes a compatibility comparison between the implemented
project and the installed system) or save the configuration in a file in order to change it later on
or keep it as a backup copy to retrieve the previous configuration.
Every time the confi guration is modifi ed by means of SecurityConfi g, relearn the
system and confi rm the sending of the confi guration.
For further information, see SecurityConfig software manual.
Programming of messages
This program function allows easy management of vocal messages of the Unit. The commands
that are available are as follows:
• Send : transfers the vocal messages from the PC to the Unit
• Listen : lets you listen to the vocal messages directly from the Unit loudspeaker
• Receive : transfers all vocal messages from the Unit to the PC, letting you change and save it
as a project file
• Import wav : lets you import audio files with the extension .wav. The duration of imported files
must not be longer than the one suggested for each message
• Listen : lets you listen to the vocal messages from the PC loudspeakers.
• Record : for recording messages through a microphone connected to the PC.
For further information, see SecurityConfig software manual.
113