Putting Into Operation - Scheppach HC 6 Traduction Du Manuel D'origine

Warning:
If an air hose is broken off or damaged, the air input on the
compressor must be switched off. A broken air hose that
is not supported, is extremely dangerous and can quickly
start to rotate, hitting people or blowing foreign bodies in
the air.
Do not try to catch the hose. Instead, immediately remove
all spectators from the dangerous area, cut off the air
input, and switch the machine off by pressing the ON/OFF
switch. Then remove the hose from the compressor.
Unpacking
Due to modern series production it is improbable that
your compressor has any defects or that a part is missing.
Should you note a fault, however, do not switch the
machine on before the parts are replaced or the fault has
been remedied. Not observing this instruction can lead to
serious injuries.

Putting into operation

1 Make sure the place of setting up is clean, dry, and
well vented.
Warning: When equipment is attached, compressed air
can escape! For this reason the outlet openings of the
equipment should never be aimed towards the operator or
other persons. Check the excessive pressure vent daily!
Switching on and off the compressor
1 Check the model plate on the compressor: 230 – 240
V (or 110 – 120 V).
2 Plug the compressor cable into a standard socket (240
V or 120 V) and switch the compressor on.
3 For switching the compressor on, push the ON/OFF
switch (3) to I.
4 For switching the compressor off, push the ON/OFF
switch to O.
5 to be able to use the nozzles, please connect them with
the hose (scope of delivery) of the inflating gun.
Attention! Tires are just allowed to be filled with a calibrated
tire inflating gun.
Operation
Fig. 1
1 The pressure in the tank is controlled by the pressure
switch under the pressure switch cover. When the maxi-
mum pressure set is reached, the pressure switch is
activated and the motor switched off. The pressure is
reduced as the air is consumed by the connected tool,
until the minimum pressure set is reached. Then the
pressure switch re-engages the motor. The operator at
the compressor should take care that the motor engages
and disengages dictated by the influence of the increas-
ing and decreasing pressure in the tank. The motor
engages without any previous warning.
2 The maximum and minimum pressure have been set in
the works. These settings may not be altered.
international 19