Scheppach HC 6 Traduction Du Manuel D'origine page 25

Failure
Motor does not start, runs too slowly,
or gets extremely hot.
Vibrations or strange noise.
Insufficient pressure or drop in output
capacity.
Trouble-shooting
Possible cause
Fault in electric current or mains
voltage too low.
Electric cable too long or too thin.
Faulty pressure switch.
Faulty motor.
Loose parts.
Foreign body in compressor.
Motor runs too slowly.
Dirty filter cartridge.
Leakage in safety valve.
Leakage in tube.
Gasket damaged.
Valve seat damaged or covered with
carbon layer.
Remedy
Check mains voltage.
Get a new cable from your dealer.
Have it repaired or replaced by your
dealer.
Have it repaired or replaced by your
dealer.
Have checked by your dealer and
repaired, if needed.
Have checked by your dealer and
repaired, if needed.
Have checked by your dealer and
repaired, if needed.
Clean or replace filter cartridge.
Have switch repaired or replaced by
your dealer.
Have checked by your dealer and
repaired, if needed.
Have checked by your dealer and
repaired, if needed.
Have checked by your dealer and
repaired, if needed.
international 25