Scheppach HC 6 Traduction Du Manuel D'origine page 11

ized persons must observe a safety distance from the
working zone.
• Working clothes. Wear close fitting clothes. Take off
jewels as they could get caught in moving machine
parts. Protect long hair by a net or cap.
• Use the compressir only in enclosed spaces.
• Do not misuse the electric cable. Do not remove the
plug from the socket by pulling the cable. Keep the ca-
ble away from heat, oil and surfaces with sharp edges.
Do not step on the cable, and do not squeeze it by put-
ting heavy weights on it.
• Carefully service the compressor. Regularly check the
electric cable. In case of a defect, have it repaired or
replaced by an authorized service station. Carefully in-
spect the compressor from outside and have any de-
fects repaired by a service station.
• Attention. Keep your mind at what you are doing. Use
your common sense. Never work with the compressor
when you are tired, or under influence of alcohol, drugs,
or medicines causing drowsiness.
• Check the compressor for any defective parts or loss of
air. Before you use the compressor again, check the cor-
rect position of the moving parts, cables, manometer,
compressed air connections and all other parts impor-
tant for the correct operation. Defective components
must be repaired or replaced by an authorized service
station, observing the instructions given in this manu-
al. The compressor may not be used with the pressure
control valve defective.
• The compressor may only be used for the purposes
specified in this operating manual. Do not allow chil-
dren or inexperienced persons work with the compres-
sor. The compressor is a machine generating com-
pressed air. Use it according to the instructions given
in this manual. Any other use exceeds authorization.
The manufacturer is not responsible for any damages
resulting from unauthorized use; risk is the sole respon-
sibility of the operator.
• Keep the venting grids clean, especially when working
in dirty conditions.
• Use the compressor at the rated voltage indicated on
the model plate with the electrical data. The admissible
tolerance range is +/- 5 %.
• Never use a defective compressor. If, during operation,
you note a strange noise, excessive vibrations or any de-
fects, switch it off immediately, check its good working
order or contact your authorized service station.
• Only use original spare parts. The use of non-original
spare parts renders the warranty invalid, and it can
cause a malfunction of the compressor. Do not make
any arbitrary modification on the compressor. Have re-
pairs done by an authorized service station.
• Put the switch to OFF position when the compressor is
not used. Put the switch to „0" (OFF) to interrupt the
power supply.
• Do not touch the hot parts of the compressor.
• Do not switch off the compressor by pulling the elec-
tric cable.
• Compressed air circuit. Use compressed air hoses and
tools made for a higher (or identical pressure) than the
maximum operating pressure of the compressor.
international 11