7.7
Installing/Removing Elevating Legrests
MyOn and MyOn Active
For this procedure, refer to FIGURE 14 on page 93 and FIGURE 15 on page 94.
For maintenance and/or adjustment procedures, refer to Troubleshooting and Maintenance on page 37.
Installing
1.
Place elevating legrest (A) on the outside of the wheelchair and insert mounting pin (B) of the legrest into the mounting tube (C) of the wheelchair.
2.
Rotate elevating legrest toward the inside of the wheelchair until it locks in place.
The calfpad (D) of the legrest will be on the inside of the wheelchair when locked in place.
3.
Repeat STEPS 1-2 for the other elevating legrest assembly.
FIGURE 14
Part No 1167417
A
B
Installing/Removing Elevating Legrests - MyOn and MyOn Active - Installing
93
7 WHEELCHAIR OPERATION
C
D
™
Invacare® MyOn