Adjusting The Height, Depth And Angle Of The Armpad Hemi - Invacare MyOn Active Manuel De L'utilisateur

2 ARMS
2.3

Adjusting the Height, Depth and Angle of the Armpad Hemi


For this procedure, refer to FIGURE 3 on page 51.
Adjusting the Height
1. Remove the armpad hemi (A) from the wheelchair. Refer to Removing/Installing the Armpad Hemi on page 49.
2. Loosen the mounting screw (B).
3. Adjust armpad to desired height based upon preset adjustment holes (C).
4. Tighten mounting screw.
Adjusting Depth
1. Loosen the three mounting screws (D).
2. Slide armrest pad (E) to desired depth.
3. Retighten the three mountings screws.
Adjusting the Angle
1. Push the end of the armpad hemi (A) and rotate to one of four preset adjustment angles (0°, 15°, 30°, 45°)
™
Invacare® MyOn
50
Part No 1167417