Invacare MyOn Active Manuel De L'utilisateur page 34

5 SAFETY INSPECTION
Wheel/fork assembly has proper tension when caster is spun. Caster should come to a gradual stop.

CAUTION
As with any vehicle, the wheels/casters and tires should be checked periodically for cracks, flat spots and wear, and should
be replaced.
Loosen/tighten locknut if wheel wobbles noticeably or binds to a stop.

Wheel bearings are clean and free of moisture.

Ensure all caster/wheel/fork/headtube fasteners are secure.

Wheel locks do not interfere with tires when rolling.

Wheel lock pivot point are free of wear and looseness.

 Wheel locks are easy to engage.
 Inspect tires/casters for flat spots and wear.
Check pneumatic tires for proper inflation (recommended tire pressure is listed on the side wall of the tire).

CAUTION
DO NOT use WD-40®, 3-in-1 Oil®, or other penetrating lubricants on quick-release axles. Otherwise, binding and/or
damage to the wheelchair may occur.
Clean quick-release axles with a Teflon

Ensure axles are free from dirt, lint, etc.

Ensure roller bearings are free from dirt, lint, etc.

Adjust wheel locks as tires wear.

 Clean and wax all parts.
 Clean upholstery and armrests with mild soap and water.
 Ensure casters are free of debris.
 Clean upholstery and armrests with mild soap and water.
 Check that all labels are present and legible. Replace if necessary.
™
Invacare® MyOn
®
lubricant.
34
Part No 1167417