7.6
Installing/Removing Front Riggings
MyOn and MyOn Active
For this procedure, refer to FIGURE 11 on page 90 and FIGURE 12 on page 91.
For maintenance and/or adjustment procedures, refer to Troubleshooting and Maintenance on page 37.
Installing
1.
Position the front rigging assembly (A) to the side of the wheelchair frame (B).
2.
Insert footrest mounting pin (C) into mounting tube (D).
3.
Rotate the front rigging assembly towards the inside of the wheelchair until it locks into place.
The footplate will be on the inside of the wheelchair when locked in place.
4.
Repeat this procedure for the other front rigging assembly.
Part No 1167417
A
FIGURE 10
Folding Wheel Lock Handles
89
7 WHEELCHAIR OPERATION
A
Invacare® MyOn
™