Electronic Emission Notices - SciCan STATIM 2000 G4 Manuel De L'utilisateur

4. Canada — Industry Canada (IC)
4.1. Approved wireless devices
This section presents the IC Certification and model number of each wireless device.
4.2. Preinstalled wireless LAN adapter
IC:9154A-GS2011MIE (Model GS2011MIE)
4.3. Low power license-exempt radio communication devices (RSS-210)
Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the
device. The transmitter devices have been designed to operate with the antennas integrated in the sterilizer, and
having a maximum gain of within 3 dBi.
4.4. Exposure of humans to RF fields (RSS-102)
The STATIM unit employs low gain integral antenna that do not emit RF field in excess of Health Canada limits for
the general population; consult Safety Code 6, obtainable from Health Canada's Web site at http://www.hc-sc.gc.ca/
The radiated energy from the antennas connected to the wireless adapters conforms to the IC limit of the RF
exposure requirement regarding IC RSS-102, Issue 2 clause 4.1
5.

Electronic emission notices

5.1. Federal Communications Commission (FCC) Declaration of Conformity
Note: The wireless adapters (Model: GS2011MIE) underwent certification process for the FCC Part 15 Subpart B
compliance under the respective FCC ID number.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult an authorized dealer or service representative for help.
SciCan LTD. is not responsible for any radio or television interference caused by unauthorized changes or modifica-
tions to this equipment. Unauthorized changes or modifications could void the user's authority to operate the equip-
ment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Responsible Party:
SciCan LTD.
1440 Don Mills Road
Toronto, Ontario, Canada
M3B 3P9
Telephone: 1.800.667.7733
61