Assigning Unit Identifier Number; Creating A User Id And Pin; Setting Up Process Enforced Usage - SciCan STATIM 2000 G4 Manuel De L'utilisateur

3 Setting up your STATIM

3.10 Assigning Unit Identifier Number

1.
Unit No
2. Scroll to
3. Using the keypad, select a maximum of 3 digits to be used as the unit's identifier number. Press
to save and to return to the Setup menu.

3.11 Creating a User ID and PIN

1.
User
2. Scroll to
3. From the SETUP PIN screen, you can assign up to four PINs. Select one of the User icons to assign
a PIN.
4. Using the keypad, assign a PIN of up to four digits and press
the confirmation screen.
Setup PIN
5. If all of the information presented in the confirmation screen is correct, press OK to be returned to
the PIN USER screen. To make a correction, select the PIN User you want to change and repeat
the process described above.

3.12 Setting Up Process Enforced Usage

When process enforced usage is activated, users are required to enter a PIN both at the beginning and
at the end of a cycle. For Process Enforced usage to function, User IDs and PINs must first be assigned.
To set up User ID and PINs, refer to Section Creating a User ID and PIN. To activate Process Enforced
usage, follow these steps:
1.
2. Scroll to Process Enforced
3. Use to toggle Process Enforced function ON or OFF. Press
return to the Setup menu.
NOTE: Any user can stop a cycle and remove the cassette even with Process Enforced usage ON.
However, the cycle data will record that an unauthorized user has stopped the cycle and/or removed
the cassette.
and select.
and select.
PIN Setup
1 2 3
4 5 6
7 8 9
CL 0 EN
and select.
15
to save and
EN
0000
to move to
User x
PIN Updated
New PIN xxxx
OK
to save your selection and
EN