SciCan STATIM 2000 G4 Manuel De L'utilisateur page 60

are capable of WPA2.
2.2. Passphrase quality & lifespan
A secure network passphrase greatly enhances network security, so it is important to select an effective passphrase.
In general, increasing length, complexity and randomness all improve the quality of a passphrase. Wi-Fi Alliance
recommends that a passphrase is at least eight characters long, and includes a mixture of upper and lower case
letters and symbols. A passphrase should not contain a word found in a dictionary and should not include personal
information (identification number, name, address, etc).
Periodically changing the passphrase on your network also increases security.
See more at: http://www.wi-fi.org/discover-wi-fi/security#sthash.tk28zkHJ.dpuf
2.3. Wireless Setup
The STATIM unit allows for Wireless or Wired connections, but only one type at a time.
2.3.1. Selecting between the Wired and Wireless networks
2.3.2. Connecting to a Wireless network
3. USA — Federal Communications Commission (FCC)
3.1. Approved wireless devices
This section presents the FCC ID and model number of the wireless device
3.2. Preinstalled wireless LAN adapter
FCC ID: YOPGS2011MIE (Model: GS2011MIE)
3.3. FCC ID location
3.3.1. On the rear side of your STATIM Sterilizer, you will find an indicator label of the format "Contains FCC
ID YOPGS2011MIE", where YOPGS2011MIErepresents the FCC ID that corresponds to your preinstalled
Wireless LAN module.
3.4. FCC RF Exposure compliance
The total radiated energy from the Main antenna connected to the Wireless Card conforms to the FCC limit of the
SAR (Specific Absorption Rate) requirement regarding 47 CFR Part 2 section 1093, when the sterilizer was tested.
The transmission antenna for the Wireless Card are located in the front fascia.
3.5. Radio Frequency interference requirements
The device has been tested and found to comply with the limits for a Class B digital device pursuant to FCC Part 15
Subpart B.
Due to differences in channel allocation, if you cannot connect using the WIFI device, it may be because these
channels are not available in your region or due to interference. If this occurs, the Ethernet connection should be
used.
60