Setting Up And Using Your Statim G4 Web Portal; Connecting To A Network - SciCan STATIM 2000 G4 Manuel De L'utilisateur

3 Setting up your STATIM

3.19 Setting up and Using your STATIM G4 Web Portal

The STATIM G4 web portal is a direct connection to the STATIM on your local area network. It is
protected by your firewall and not accessible to outside users (unless they have a Remote Access
Code. For more information, see Section 7. Retrieving a Remote Access Code). The web portal provides
real-time cycle information and archived sterilization records unique to this unit. From here, you can
print reports, set up email notification and search cycle histories. To set up your web portal follow the
instructions available on the portal's 'HELP' tab.

3.20 Connecting to a Network

The STATIM G4 has a 10/100Base-T Ethernet port located at the back of the unit. To connect your
STATIM to a network using a router, follow these steps:
1. Connect your network cable to the Ethernet port at the back of the unit. If your office uses a router,
the router should automatically assign the unit an IP address. You will know the IP address has been
assigned when the red X over the Network icon disappears.
NOTE: In some circumstances, where you do not have a router, for example when using Windows
Network Sharing, you may have to assign a dedicated or 'static' IP address. To assign a static IP
address, contact your local network administrator.
2 From the main screen, press the Network icon. The Network screen displays information about your
STATIM's connectivity, including its IP address.
mm/dd/yyyy hh:mm:ss
SELECT A CYCLE
3 Type the IP address displayed on the touchscreen into the browser of any web enabled device to
access your unit's web portal. You will know that an IP address has been assigned when the red X
over the Network icon disappears. When the Network icon is active (for example when sending email)
it will turn green.
18