Connection Procedures - Ingersoll Rand 80445703 Guide De Démarrage Rapide

4. Refer to the torque values listed on side of the contactor when
tightening the wire terminal screws.
5. The overload current setting formula is as follows:
Motor Nameplate Amps X Motor Service Factor = Overload
Setting
Example: 10.0 (Motor Amps) x 1.15 (Service Factor) = 11.50 Overload
Setting
GASOLINE ENGINE COMPRESSORS
NOTICE
If you will be making connections to a remote battery, the
engine on the compressor must be equipped with an alternator.
BATTERy. A 12 volt battery with a minimum current rating of 250
CCA (cold cranking amps) and minimum ampere-hour rating of 24 Ah
should be sufficient for cranking most electric start engines.
BATTERy CABLES. Refer to the following table for size and length
recommendations.
Cable Size (GA)
6
4
2

CONNECTION PROCEDURES:

1) Connect the battery positive (+) cable (A) to the starter solenoid
terminal (B).
Kohler Engine Battery (+) Positive cable connection point
80445703 Rev. H
RELEASED 05/Apr/2018 15:16:08 GMT
Maximum Length
5' (1.5 m.)
7'-2.5" (2.1 m.)
12' (3.6 m.)
B
D
D
Honda Engine Battery (+) Positive cable connection point.
NOTE: Circuit Fuse location at (D). Electric Start will not work if Fuse is
blown. Unit can be rope started, however will not charge the Battery if
Fuse is blown.
2) Connect the battery negative (-) cable (C) to the bolt shown in
the following illustration. Secure the wire in place by screwing a
suitably-sized nut onto the bolt and down onto the terminal.
3) Connect the battery positive (+) cable (A) to the battery positive
(+) terminal.
4) Connect the battery negative (-) cable (C) to the battery negative
(-) terminal.
5) Coat the terminals and cable ends with corrosion-preventive
grease.
WARNING
Remove the cable from the negative (-) side of the battery
before servicing.
Refer to the engine manufacturer's instructions for more information.
B
EN-7