Using The Qr Code - Ingersoll Rand 80445703 Guide De Démarrage Rapide

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Select constant speed control if the compressor restarts in less than 10
minute intervals or runs more than 40 minutes per hour. Turn the knob
fully counterclockwise to run the compressor continually.
NOTICE
The auxiliary valve is factory preset at 5 PSIG lower than the
factory pressure switch setting.
CAUTION
Running unloaded for more than 20 minutes per hour or more
than 15 minutes continually with the use of constant speed
control will cause oil pumping and should be avoided.
START-UP (GASOLINE ENGINE COMPRESSORS)
WARNING
Do not operate gasoline engine compressors in an enclosed
area.
1)
Release any residual tank pressure by slowly opening the
manual drain valve.
2)
Turn on the engine gasoline supply.
3)
Put the choke in the "on" position.
4)
Close the service valve and put the unloader lever in the
"unload" (A) position.
Unloader
Unloader
5) Start the engine, release the choke, and allow the engine to
warm up for two to three minutes.
6) Return the unloader lever to the "load" (B) position.
NOTICE
Turn the gasoline supply off when the compressor is not being
used.
NOTICE
Some gasoline engine driven compressors require 5-8 break-in
hours of operation before reaching full capacity and speed.
COMPRESSOR CONTROLS (GASOLINE ENGINE
COMPRESSORS)
CONSTANT SPEED CONTROL. This type of control applies to gasoline
engine compressors.
When the receiver tank pressure reaches the factory preset maximum
pressure, the unloader slows down the engine and the compressor
stops pumping. When the receiver tank pressure drops to the factory
preset minimum, the unloader resets, the engine returns to full speed,
and the compressor resumes pumping.
80445703 Rev. H
RELEASED 05/Apr/2018 15:16:08 GMT

USING THE QR CODE

Scan QR code located on compressor to download detailed
installation, operation, maintenance, troubleshooting and repair parts
information not covered in this manual. More information is available
at www.IRrecip.com.
If Quick Start Manual or QR code label are damaged, and you wish
to order paper copies of any of the documents, contact your local
Ingersoll Rand dealer.
EN-9

Publicité

Table des Matières
loading

Table des Matières