Location In The Plant; Discharge Piping - Ingersoll Rand IRN 15 HP Manuel D'utilisation Et D'entretien

22
INSTALLATION / HANDLING
KEY
1. Compressor
2. Air Receiver
3. Air Dryer
4. Compressed air filters
5. System demand points
NOTE
Items [2] to [5] are optional or may be existing items of plant. Refer
to your Ingersoll Rand distributor / representative for specific
recommendations.

LOCATION IN THE PLANT

The compressor can be installed on any level floor capable of
supporting it. A dry, well ventilated area where the atmosphere is clean
is recommended. A minimum of 1m (3ft) should be left all around
machine for adequate service access and ventilation.
Adequate clearance needs to be allowed around and above the
machine to permit safe access for specified maintenance tasks.
Ensure that the machine is positioned securely and on a stable
foundation. Any risk of movement should be removed by suitable
means, especially to avoid strain on any rigid discharge piping.
CAUTION
Screw type compressors [1] should not be installed in air
systems with reciprocating compressors without means of
isolation such as a common receiver tank. It is recommended that
both types of compressor be piped to a common receiver using
individual air lines.
en
CAUTION
The use of plastic bowls on line filters and other plastic air line
components can be hazardous. Their safety can be affected by
either synthetic coolants or the additives used in mineral oils.
Ingersoll Rand recommends that only filters with metal bowls
should be used on any pressurised system.
CAUTION
The Basic compressor or Total Air System Package, is not
suitable for operation in temperatures liable to cause freezing as
Condensate water is liable to be produced in the after cooler and
receiver where fitted.
Refer to your Ingersoll Rand distributor for further information

DISCHARGE PIPING

Discharge piping should be at least as large as the discharge
connection of the compressor. All piping and fittings should be suitably
rated for the discharge pressure.
It is essential when installing a new compressor [1], to review the
total air system. This is to ensure a safe and effective total system. One
item which should be considered is liquid carryover. Installation of air
dryers [3] is always good practice since properly selected and installed
they can reduce any liquid carryover to zero.
It is good practice to locate an isolation valve close to the
compressor and to install line filters [4].
If you have purchased a TAS model, your compressor package
already includes items [1], [3] and [4].
It is a requirement for air dryers covered under Aircare that correctly
sized Ingersoll Rand pre and afterfilters are installed.
http://air.ingersollrand.com