HellermannTyton Relilight Mode D'emploi page 12

Installation
5 .5 Installing the Relilight V 41 U1
Proceed as follows:
1 Strip the cable as shown in the figure and align the
cores.
10 mm
Stripping the cable.
2 Insert the cables into the bottom shell.
Inserting the cables.
3 Connect the cores with the connector block or solder
them together in the core guide.
Connecting the cores.
A: Connector
B: Core guide (solder)
12
8,0 - 10,0 mm
4 x 0,5 - 4 x 1,0 mm²
40 mm
Operating Instructions • Relilight • 09-2016
4 Push the connector into the bottom shell.
Inserting the connector.
5 Position the strain relief.
Positioning the strain relief.
6 Tighten the strain relief.
Tightening the strain relief.