Introduction; Product Description (Fig. 1 - 17) - Scheppach Hm140L Traduction Des Instructions D'origine

1.

Introduction

Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new product brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this product assumes no liability
for damage to the product or caused by the product
arising from:
• Improper handling
• Non-compliance with the operating manual
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Application other than specified
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100,
DIN 57113 / VDE0113 not being observed
Note:
Read through the complete text in the operating manu-
al before installing and commissioning the device.
This operating manual should help you to familiarise
yourself with your product and to use it for its intended
purpose.
The operating manual includes important instruc-
tions for the safe, proper and economic operation of
the product, for avoiding danger, for minimising repair
costs and downtimes and for increasing the reliability
and extending the service life of the product.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the product in your country.
Keep the operating manual package with the power
tool at all times and store it in a plastic cover to pro-
tect it from dirt and moisture. They must be read and
carefully observed by all operating personnel before
starting the work.
The product may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards.
The required minimum age must be observed.
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such products must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.

2. Product description (Fig. 1 - 17)

1. Handle
2. On/off switch
3. Locking switch
4. Moving saw blade guard
5. Moveable stop rail
6. Stop rail
7. Workpiece support
8. Fixed saw table
9. Table inlay
10. Locking handle
11. Indexed position lever
12. Pointer
13. Scale
14. Rotary table
15. Clamping device
16. Set screw for moveable stop rail
17. Laser / LED
18. Dust bag
19. Machine head
20. Sawing shaft lock
21. Machine head locking pin
22. Scale
23. Pointer
24. Locking screw (incline machine head)
24a. Locking pin
25. Cable routing
26. Slide rail locking screw
27. Screw for cutting depth limiting
28. Stop for cutting depth limiting
29. Adjustment screw (45°)
30. Adjustment screw (90°)
31. Locking screw for workpiece support
32. Laser screw
33. Outer flange
34. Flange screw
35. Saw blade
36. Inner flange
37. Laser on/off switch
www.scheppach.com GB | 27