Residual Risks; Technical Data - Scheppach Hm140L Traduction Des Instructions D'origine

• Never open the laser module. Unexpected exposure
to the beam can occur.
• If the mitre saw is not used for an extended period
of time, the batteries should be removed.
• The laser may not be replaced with a
different type of laser.
• Repairs of the laser may only be carried out by the
laser manufacturer or an authorised representative.

6. Residual risks

The product has been built according to state-of-
the-art and the recognised technical safety rules.
However, individual residual risks can arise during
operation.
Despite use as intended, specific risk factors cannot be
entirely eliminated. Due to the design and layout of the
machine, the following risks remain:
• Contact with the saw blade in the exposed sawing
area.
• Reaching into the running saw blade (cutting injury).
• Kick-back of workpieces and workpiece parts.
• Saw blade breakage.
• Ejection of faulty carbide parts of the saw blade.
• Hearing damage when the necessary hearing pro-
tection is not used.
• Harmful emissions of wood dusts during use in en-
closed areas.
• Health hazard due to electrical power, with the use
of improper electrical connection cables.
• Furthermore, despite all precautions having been met,
some non-obvious residual risks may still remain.
• Residual risks can be minimised if the "Safety In-
structions" and the "Intended Use" together with the
operating manual as a whole are observed.
• Avoid accidental starting of the product: the oper-
ating button may not be pressed when inserting the
plug in a socket.
• Use the tool attachment that is recommended in this
operating manual. This is how to ensure that your
product provides optimum performance.
• Keep your hands away from the working area when
the product is in operation.
• Do not unnecessary stress the machine: too much
pressure when sawing will damage the saw blade
quickly. This results in reduced output of the ma-
chine in the processing and in cut precision.
• When cutting plastic material, please always use
clamps: the parts which should be cut must always
be fixed between the clamps.
32 | GB
• Before performing setting or maintenance work, re-
lease the start button and pull out the power plug.
7.

Technical data

AC motor
Power
Idle speed
Carbide saw blade
Number of teeth
Pivot range
Mitre cut
Saw width at 90°
Saw width at 45°
Saw width at 2 x 45° to
the right (double mitre
cut)
Saw width at 2 x 45° is on
the left (double mitre cut)
Protection class
Weight
Laser class
Laser wavelength
Power of laser
* Operating mode S6, uninterrupted, periodic op-
eration. The mode comprises of a start-up peri-
od, a time with constant load and an idle time.
The operating time is 5 mins, the relative duty
cycle is 40% of the operating time.
** Operating mode S1: Continuous operation with
constant load.
The workpiece must have a minimum height of 3
mm and a minimum width of 10 mm.
Make sure that the workpiece is always secured
with the clamping device.
Noise and vibration
The noise and vibration levels have been determined
in accordance with EN 62841.
www.scheppach.com
220 - 240 V~ 50Hz
2000 Watt / S6 40%*
1800 Watt / S1 **
3800 rpm
ø 305x ø 30 x 3/2.8 mm
24/48
-45 ° / 0° / +45 °
0° to 45° left/right
330 x 105 mm
230 x 60 mm
230 x 35 mm
230 x 60 mm
II
20.5 kg
2
650 nm
≤ 1 mW