To Apply And Release The Parking Brake; To Get A Good Mowing Result; Maintenance; Introduction - Husqvarna RC 318T Manuel D'utilisation

2. Turn the ignition key to the STOP position.
3. When the product stops, apply the parking brake.

To apply and release the parking brake

1. Press the parking brake pedal down (1).
2. Press and hold the lock button (2).
1

Introduction

WARNING! Before you do any maintenance
work you must read and understand the
safety chapter.

Maintenance schedule

* = General maintenance done by the operator. The
instructions are not given in this operator's manual.

Maintenance

Make sure that nuts and screws are tightened
Make sure that there are no fuel or oil leaks
63 - 005 - 03.02.2017
2
Maintenance
3. Keep the button pressed and release the parking
brake pedal.
4. To release the parking brake, press the parking
brake pedal again.

To get a good mowing result

• Do not mow a wet lawn. Wet grass gives inferior
results.
• Start with a high cutting height and lower it gradually.
• Mow with blades that rotate at high speed (highest
permitted engine speed, see
34 ). Move the product forward at low speed. If the
grass is not too high and thick, you can get a good
mowing result also at a higher speed.
• We recommend to use the product in collect mode.
To get the best mowing result in non-collect mode,
cut the grass frequently. To cut the grass frequently
does not take more time. The grass is shorter and
you can mow at a higher speed.
• The product can also be used to collect leaves on
the lawn. Set a high cutting height and set the
product in collect mode.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an authorized service agent do the
maintenance.
Note: If more than one time interval is marked in the
table, the shortest time interval is for the first
maintenance only.
Daily maintenance
before operation
*
*
Technical data on page
Maintenance interval
in hours
25 50 100 200
19