To Remove The Cutting Deck - Husqvarna RC 318T Manuel D'utilisation

9. Lift the cutting height stay from the stay holder and
put it in the hole for the cutting height stay (1).
10. Put the drive belt around the tension wheel (2). Make
sure the drive belt runs as illustrated below.
11. Put the spring in the spring holder (3).
12. Set the lift lever for the cutting deck in locked
position. The cutting deck lifts.
13. Pull the auger servicing position lever to up position.
14
1
2
3
14. Attach the front cover.

To remove the cutting deck

To attach the cutting deck on page
1. Do steps 1–6 in
13 .
2. Pull the spring handle to the right out from the spring
holder to loosen the tension on the tension wheel for
the drive belt. (1)
3. Hold the spring handle with your left hand and lift off
the drive belt with your right hand.
4. Pull the drive belt to the rear below the product. Do
not put it in the belt holder (2).
5. Put the spring handle in the spring holder to prevent
that the spring falls down.
6. Lift the cutting height stay and put it in the holder for
the cutting height stay (3).
7. Hold the front edge of the cutting deck with two
hands and pull forward until it stops.
8. Lift the service lock to vertical position.
3
2
1
63 - 005 - 03.02.2017