Service; Warranty; Transmission Warranty; Ec Declaration Of Conformity - Husqvarna RC 318T Manuel D'utilisation

Cutting deck
Cutting width, mm
Cutting height, 8 positions, mm
Weight, kg
Blade length left and right blade, mm
Blade length centered blade, mm
Blades
Left blade article number
Right blade article number
Centered blade article number
WARNING! To use a cutting deck that is not
approved for the product can cause objects
to eject at high speed and cause serious

Service

Do a yearly check at an authorized service center to
make sure that the product functions safely and at its
best during high season. The best time to do a servicing
or overhaul of the product is low season.

Transmission warranty

Applies to RC 320Ts AWD only.
The transmission warranty is only applicable if checks
are done of the front and rear wheel rotation speed as

EC Declaration of Conformity

Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel:
+46-36-146500, declares that the Husqvarna ride-on
lawn mower RC 318T and RC 320Ts AWD from 2014's
serial numbers and onwards (the year is clearly stated in
plain text on the rating plate with subsequent serial
number), comply with the requirements of the
COUNCIL'S DIRECTIVE:
• of May 17, 2006 "relating to machinery" 2006/42/EC
• of February 26, 2014 "relating to electromagnetic
compatibility" 2014/30/EU
36
Service

Warranty

EC Declaration of Conformity
Combi 112
1120
25–75
63
555
243
588 82 43-10
588 82 43-20
588 82 44-10
injury. Do not use other cutting deck types
than specified in this owner's manual.
When you send an order for the spare parts, give
information about the purchase year, model, type, and
serial number.
Always use original spare parts.
given in the maintenance schedule. To prevent damage
to the transmission system, let an authorized service
agent adjust it. Refer to the table values specified in the
workshop manual.
• of May 8, 2000 "relating to the noise emissions in the
environment" 2000/14/EC
Information regarding noise emissions and the mowing
width, see Technical data.
The following harmonised standards have been applied:
EN ISO 12100, EN ISO 5395-1, EN ISO 5395-3, EN ISO
14982
If not otherwise stated, the above listed standards are
the latest published versions.
Notified body: 0404, SMP Svensk Maskinprovning AB,
Box 7035, SE-750 07 Uppsala has issued reports
63 - 005 - 03.02.2017