Assembly; Introduction; To Attach The Cutting Deck - Husqvarna RC 318T Manuel D'utilisation

• Make sure that all nuts and bolts are tightened
correctly and that the equipment is in good condition.
• Do not change the adjustment of governors. If you
run too fast, you risk damage to the machine

Introduction

WARNING! The drive belt tension spring can
break and cause injury. Wear protective
glasses when you attach or remove the
cutting deck.
Read the assembly instructions in the owner's manual
carefully. A label on the inner side of the front cover on
the product, also shows how to attach and remove the
cutting deck.

To attach the cutting deck

1. Place the product on level ground.
2. Apply the parking brake.
3. Set the cutting height lever in the servicing position.
4. Set the lift lever for the cutting deck in mowing
position.
5. Lower the auger servicing position lever to lift the
auger to servicing position.
6. Put the drive belt as illustrated to make sure that it
does not get pinched when the cutting deck is
attached.
63 - 005 - 03.02.2017
components. See
highest permitted engine speed.
• The product is approved only with the equipment
supplied or recommended by the manufacturer.

Assembly

7. Push the equipment frame down. Lift the service lock
to vertical position.
8. Lift the front edge of the cutting deck and move it
into the equipment frame. The plugs on the cutting
deck, one on each side, must be put in the grooves
on the equipment frame. The service lock releases
automatically.
Technical data on page 34 for
WARNING! The lock mechanism
can cause injury to fingers if you do
not operate it carefully. Put the
service lock in full vertical position
and hold the front edge of the
cutting deck with two hands when
you continue to the next step.
13