To Use The Product In Non-Collect Mode; To Stop The Engine - Husqvarna RC 318T Manuel D'utilisation

more braking power. This can be necessary for
example when you brake on a slope.
6. Select cutting height (1–8) with the cutting height
lever.
7. Press the lock button on the lift lever for the cutting
deck and lower it to mowing position.
8. When the collector is full, a symbol (see
control switch with LED indicators on page 6 ) lights
up in orange on the auger control switch and a beep
is heard.
Note: The beep that sounds when the collector
is full can be blocked out by the hearing
protection. Look at the auger control switch
regularly to not miss when the collector is full.
9. Set the lift lever for the cutting deck in locked
position. The cutting deck lifts and the blades stop to
rotate.
10. To empty the collector, press the rear part of the
switch used to tilt the collector. The collector lifts.
Hold the switch pressed until the hatch opens and
the grass falls out.
18
11. Press the front part of the switch to lower the
collector to operating position.
Note: If the collector is fully tilted or lowered and you
continue to press the switch, a clattering sound is heard.
This shows that the collector is at the end positions.

To use the product in non-collect mode

1. Start the engine.
2. Make sure that the symbol on the auger control
button is blue. This shows that the product is in non-
collect mode. See
indicators on page 6 for information on what to do if
Auger
the symbols on the auger control switch lights up or
the auger control button is red.
3. Do steps 4–8 in
on page 17 .
4. When you start to mow, the grass is not collected.

To stop the engine

1. Pull the lift lever for the cutting deck rearward to its
locked position to lift up the cutting deck. The blades
stop to rotate.
B
A
WARNING! Fingers can get crushed
between the collector and the frame. Do not
put your hand on the frame or the collector
when the collector is lowered.
Auger control switch with LED
To use the product in collect mode
63 - 005 - 03.02.2017