To Start The Product; To Stop The Product - Husqvarna LC 151 Manuel D'utilisation

1. Open the fuel tank cap slowly to release the
pressure.
2. Fill slowly with a fuel can. If you spill fuel, remove it
with a cloth and let remaining fuel dry off.
3. Clean the area around the fuel tank cap.
4. Tighten the fuel tank cap fully. If the fuel tank cap is
not tightened, there is a risk of fire.
5. Move the product a minimum of 3 m (10 ft) from the
position where you filled the tank before a start.
To set the cutting height
1. Move the cutting height lever rearward to increase
the cutting height.
2. Move the cutting height lever forward to decrease
the cutting height.
CAUTION:
too low. The blades can hit the ground if the
surface of the lawn is not level.

To start the product

1. Make sure that the ignition cable is connected to the
spark plug.
2. Stay behind the product.
3. Hold the engine brake handle against the handlebar.
4. Hold the starter rope handle with your right hand.
1566 - 008 - 24.11.2021
Do not set the cutting height
5. Slowly pull out the starter rope until you feel some
resistance.
6. Pull with force to start the engine.
WARNING:
rope around your hand.
To use the drive on the wheels LC
151S & LB 256SP
• Push the drive bail in the direction of the handlebar.
• Release the drive bail to disengage the drive, for
example when you go near an obstacle.
• Before you pull the product rearward, disengage the
drive and push the product forward approximately 10
cm.
To use the drive on the wheels (LB
251S)
• Pull the drive lever in the direction of the handlebar.
• Push the drive lever away from the handlebar to
disengage the drive, for example when you go near
an obstacle.
Note:
The drive lever is automatically disengaged
when you release the engine brake handle.
• Before you pull the product rearward, push the drive
lever away from the handlebar and push the product
forward approximately 10 cm to fully disengage the
drive.

To stop the product

• To stop the drive only, release the drive bail (LC
151S, LB 256SP) or the drive lever (LB 251S).
• To stop the engine, release the engine brake handle.
Do not twist the starter
9