Husqvarna RC 318T Manuel D'utilisation page 32

Problem
The transmission does not have
sufficient power
The battery does not charge
There is vibration in the product
The mowing result is unsatisfac-
tory
32
Cause
The transmission cooling air intake or the cooling flanges are blocked.
The fan on the transmission is damaged.
The hydraulic oil cooling fan (RC 320Ts AWD only) is blocked. See
hydraulic oil cooler on page 22 .
The hydraulic oil cooling fan (RC 320Ts AWD only) is damaged.
There is no oil in the transmission or the oil level is too low. See
of the transmission oil level on page 30 .
The battery is defective. See
The connection at the cable connectors on the battery terminals is bad. See
tery safety on page 12 .
The battery is in protective mode. See
The collector is full. The operator has ignored the collector full signal or the sen-
sor for collector full is set in the incorrect position. See
collector full on page 16 .
The product is operated in long, thick and/or wet grass in non-collect mode. See
To get a good mowing result on page 19 .
The blades are loose. See
One or more of the blades are unbalanced. See
28 .
The auger is damaged.
The engine is loose.
The blades are blunt. See
The grass is long or wet. See
The cutting deck is skew.
There is grass blockage in the cutting deck. See
21 .
The tire pressure is different on the right and left sides. See
sure on page 25 .
The product is operated at a too high speed. See
on page 19 .
The engine speed is too low. See
The drive belt slips.
Battery safety on page 12 .
To charge the battery on page 25 .
To examine the blades on page 28 .
To examine the blades on page
To replace the blades on page 28 .
To get a good mowing result on page 19 .
To clean the product on page
To get a good mowing result
To get a good mowing result on page 19 .
To clean the
To do a check
Bat-
To adjust the sensor for
To set the tire pres-
63 - 005 - 03.02.2017