Operation; Introduction; To Fill Fuel; To Adjust The Seat - Husqvarna RC 318T Manuel D'utilisation

Introduction

WARNING! Before you operate the product,
you must read and understand the safety
chapter.

To fill fuel

WARNING! Gasoline is very flammable. Be
careful and refuel outdoors (see
on page 12 ).
The engine runs on unleaded gasoline with a minimum
octane rating of 85 (not mixed with oil). We recommend
biodegradable alkylate gasoline. (max. methanol 5%,
max. ethanol 10%, max. MTBE 15%).
Do a check of the fuel level before each use and refuel if
necessary.
You can clearly see the fuel level in the fuel tank and
there are marks for empty tank, tank filled ¼, tank filled
½ and for full tank. Do not fill above the mark that shows
full tank.

To adjust the seat

The seat can be tilted forward. It can also be adjusted
lengthways. Loosen the handles below the seat to adjust
it forward or rearward.
63 - 005 - 03.02.2017
9. Lift the front edge of the cutting deck until the service
lock touches the frame and pull the cutting deck out.

Operation

Fuel safety
To engage and disengage the drive
system
To move the product with the engine off, the drive
system must be disengaged. Pull out the drive system
lever fully to disengage the drive on the axle. Push the
drive system lever in fully to engage the drive on the
axle. Do not use middle positions.
The drive system lever for model RC 318T is found
behind the left rear wheel. Model RC 320Ts AWD has
one drive system lever for the front and one for the rear
axle. The drive system lever for the rear axle is found
behind the left rear wheel.
WARNING! The lock mechanism
can cause injury to fingers if you do
not operate it carefully. Put the
service lock in full vertical position
and hold the front edge of the
cutting deck with two hands when
you continue to the next step.
15