Dismantling And Assembling The Cutter; Assembling The Mulcher Plugs - Husqvarna LB448S Manuel D'utilisation

Dismantling and assembling the
cutter
WARNING! Always wear heavy-duty
!
gloves when servicing and maintaining
the cutting equipment. The cutters are
very sharp and cuts can occur very
easily.
The ignition lead should always be removed from the
spark plug before repair, cleaning or maintenance work.
Position the cutter with the spark plug upwards when
servicing the machine.
Always empty the fuel tank before you place the lawn
mower on its side.
Dismantling
• Unscrew the bolt holding the cutter.
• Remove the bolt, spring washer and cutter.
Assembly
The blade must be mounted with the angled ends pointing
up towards the cover.
• Place the cutter with the friction washer against the
cutter bracket.
• Make sure the cutter centres correctly on the shaft.
ASSEMBLY
• To avoid vibrations, place the mower cutter so that the
cutter bracket marking can be seen on the sides of the
cutter.
• Fit the washer and tighten the bolt correctly. The bolt
should be tightened with a torque of 45-60 Nm.
IMPORTANT!
Always exercise care and use your common sense.
Avoid all situations which you consider to be beyond
your capability. If you still feel uncertain about operating
procedures after reading these instructions, you should
consult an expert before continuing. Contact an
authorised service workshop.
Always use genuine parts. For more information, see
the "Technical data" section.

Assembling the mulcher plugs

• Disconnect the HT lead from the spark plug.
• Position the cutter with the spark plug upwards when
servicing the machine.
• Fit the leader pins into the holes on the cutting cover.
• Fasten the mulcher plugs from the top of the cutting
cover.
–
English 11