Assembling And Adjustments; General; Handlebar - Husqvarna LC 451S Manuel D'utilisation

General

IMPORTANT! Prevent unintentional
!
starting by removing the ignition cable
from the spark plug.

Handlebar

Assembly
1 Loosen the lower knobs on both sides of the machine.
Check that the plastic washer is correctly in place in
the recess in the handle attachment.
2 Fit the handlebar folded forward with the plastic
washer placed between it and the handle attachment.
CAUTION! Check that cables and wires run along the
inside of the handlebar and are not twisted around each
other.
3 Fasten the handlebar to the handle attachment with
screw, washer and bolt.
4 Unfold the handlebar and fasten the knob on both
sides of the machine. Adjust to a suitable height. For
more information, see "Adjustment".

ASSEMBLING AND ADJUSTMENTS

5 Place the wires in the cable bracket. Make sure the
wires are not twisted around each other. Fasten the
cable bracket underneath the handlebar.
6 Run the wires along the underside of the handlebar.
Insert the wires into the second cable bracket, which
is then fastened to the upper part of the handlebar.
7 Fix the cables to the handle support by using a cable
tie.
Settings
Handle height
• Loosen the lower knobs.
• Slide the knobs to the ends of the grooves on both
sides of the machine.
• Handle height can be set to 2 different positions,
• Adjust to a suitable height.
–
English 81