Assembling And Adjustments; General; Handle; Cutting Height - Husqvarna LC 448S e Manuel D'utilisation

General

IMPORTANT! Prevent unintentional
!
starting by removing the ignition cable
from the spark plug.

Handle

Lower handle
• Fit the lower handle on the machine with the nuts.
Top handle
• Assemble the upper handle using the handle nut on
the guide plate. Don't forget the washer between the
plate and the handle nut. No tools are needed for the
assembly.
• Attach the cables to the handle using the supplied
cable ties.
Settings
• If necessary, the handle can be turned slightly
sideways with the handle joint. The handle can be set
to different positions to achieve the best driving
position, e.g. when mowing next to hedges or house
walls.

ASSEMBLING AND ADJUSTMENTS

Handle height
• Move the handle for adjustment of the handle height
forwards with one hand and hold the handle with your
other hand. Adjust the height.
• Release the handle for adjustment of handle height
and check that the handle is in the right position and
tightly secured.

Cutting height

NOTICE! Do not set the cutting height too low as there
is a risk that the cutters might hit ground with
unevenness.
Move the lever to the back for higher cutting height and to
the front for lower cutting height.

Catcher

• Fit the catcher bag.
• Fit the bagger bottom in the discharge hole. Attach the
hooks to the protruding screws.

Mulcher insert

• Screw the steering wheel loose to mount/dismount
the mulcher insert.

Filling with oil

• The oil tank is empty at delivery. Fill the tank with the
supplied engine oil up to the mark. The engine oil
should be changed the first time after 5 hours running
time.
–
English
7