Assembling And Adjustments - Husqvarna TRIUMPH Manuel D'utilisation

General
IMPORTANT! Prevent unintentional
!
starting by removing the ignition cable
from the spark plug.
Handle
Assembly
• Assemble the upper handle using the handle nut on
the guide plate. Don't forget the washer between the
plate and the handle nut. No tools are needed for the
assembly.
Settings
• If necessary, the handle can be turned slightly
sideways with the handle joint. The handle can be set
to different positions to achieve the best driving
position, e.g. when mowing next to hedges or house
walls.
• Champion, Excellent, Excellent H, Pro 19 H The
handle can also be adjusted vertically by turning the
wheels by the attachment fitting on the chassis
• Triumph, Pro 17 H Loosen the nut. Adjust the height.
Tighten the nut.

ASSEMBLING AND ADJUSTMENTS

Cutting height
CAUTION! Do not set the cutting height too low as there
is a risk that the cutters might hit ground with unevenness.
The cutting height adjustment is spring assisted.
Champion, Excellent, Excellent H, Pro 19 H The cutting
height can be adjusted in 6 different steps.
Triumph, Pro 17 H The cutting height can be adjusted in
five different steps.
• To raise the cutting height move the lever to the left
and then forward.
• To lower the cutting height move the lever to the left
and then backward.
Mulcher insert (Champion,
Excellent, Excellent H, Pro 19 H)
On the models Champion, Excellent anf Excellent H the
mulcher insert is assembled before delivery.
On the models Champion, Excellent anf Excellent H the
mulcher insert is assembled before delivery. For Pro 19 H
the mulcher insert is supplied unassembled.
• Fit the leader pins into the holes on the cutting cover.
• Fasten the mulcher plugs from the top of the cutting
cover.
Filling with oil
• The oil tank is empty at delivery. Fill the tank with the
supplied engine oil up to the mark. The engine oil
should be changed the first time after 5 hours running
time.
–
English 7