Ryobi EDP-5530L Manuel D'utilisation page 30

GB
F D
ASSEMBLY
In order to loosen or tighten the chuck using the chuck
key, turn up the safety guard, push the key into the key
hole (m) located on the chuck. Rotate the key clockwise
to tighten the chuck or counterclockwise to loosen the
chuck, then turn down the safety guard.
WARNING
Use only the self-ejecting chuck key provided.
Always remove chuck key. Failure to heed this
warning could result in serious personal injury.
OPERATION
TABLE ROTATION (Fig. 17)
The table (7) can be rotated out of the way when drilling
large objects.
Loosen the table lock handle (25).
■
Rotate the table (7) to the desired position.
■
Retighten the table lock handle (25).
■
INSTALLING AND REMOVING BITS (Fig. 18)
Unplug the drill press.
■
Open or close the chuck jaws to a point where the
■
opening is slightly larger than the bit size you intend
to use.
Insert drill bit into the chuck the full length of the jaws.
■
WARNING
Do not insert drill bit into chuck jaws and tighten
as shown in figure 18. This could cause drill bit to
be thrown from the drill press, resulting in possible
serious personal injury or damage to the chuck.
Tighten chuck jaws securely using chuck key
■
provided. Do not use a wrench to tighten or loosen
chuck jaws.
Remove chuck key.
■
To remove the drill bit, reverse the steps listed above.
■
DRILLING (Fig. 19-20)
Using the vice (24) provided (or similar clamping
■
devices), secure the workpiece to the table.
To protect the top surface of the workpiece, use a
piece of scrap wood between the vice and the
workpiece.
E I P NL S DK N FIN
English
Select the proper drill bit based on the hole size
■
desired. For large holes, drill a pilot hole first, using a
smaller diameter bit.
Unlock the spindle lock lever and the lock knob.
■
Using the feed handles, set the spindle at the desired
depth and retighten both the lock lever and lock
knob securely.
Turning the table adjustment handle, set the table to
■
desired height.
Note: Make sure the table is free of all loose objects
and the bit is not in contact with the workpiece.
Plug the electrical cord into power supply and turn the
■
switch ON. Make sure spindle rotates freely.
With the motor running, change the spindle speed
■
with the variable speed lever (13).
Note: The digital display on the front of the drill press
will give you the exact spindle speed. Use the chart
below to determine speed for the material and
drill size.
Slowly lower drill bit into workpiece. Do not force the
■
bit; let the drill press do the work.
Once the hole is completed, allow the spindle to
■
return to its normal position. This will automatically
raise the chuck and bit.
DRILLING TIPS
If a large hole is needed, it's a good idea to drill a
■
smaller pilot hole before drilling the final one.
Your hole will be more accurately positioned, rounder,
and the bits will last longer.
If the hole is deeper than it is wide, back off
■
occasionally to clear the chips.
When drilling metal, lubricate the bit with oil to
■
improve drilling action and increase bit life.
As you increase the bit size, you may need to reduce
■
the spindle speed.
If drilling a through hole, make sure that the bit will
■
not drill into the table after moving through the
workpiece.
22
GR H CZ RUS RO PL