After Your Ride; Cleaning Your Bicycle - Rose File Plus Manuel D'instructions

Verify the tight fit of the stem: Stand in front of the bike with the front wheel between your knees and
try to turn the handlebar left and right.
→ It should not be possible to turn the handlebar with normal force.
Check the headset for play: Stand next to your bike with both hands on the handlebar. Pull the front
brake lever and gently push the bike backwards and forwards.
→ There should be no play in the headset.
Verify the tight fit of the seat post: Stand behind your bike, hold the saddle with one hand and try to turn
it left and right.
→ It should not be possible to turn the saddle or seat post.
Verify the tight fit of the grips.
→ It should not be possible to turn the grips with your hands.
Make sure that all components are tight.
→ Tighten the components to the proper torque, if necessary (see "8.4 Torques" on page 55).
Check the frame for damage and deformation.
→ There must be no damages.
Check whether all cables and hoses are in the cable clips and verify the tight fit of the clips.
→ All cables must fit firmly in the cable clips.
Check the suspension fork for damages.
→ There must be no damage, signs of damage or heavy oil leakage.
5.2

After your ride

DANGER
Risk of accident caused by brake failure or reduced braking power due to dirty brake pads or brake contact
areas!
Brake pads and brake contact surfaces must be free from lubricating substances such as grease, oil (also skin oil), wax,
silicone, teflon etc.! Brake pads or brake contact surfaces contaminated in this way must no longer be used!

5.2.1 Cleaning your bicycle

After your ride, you should clean your bike thoroughly using a soft cloth and clear water. Never use a high pressure
washer!
Stubborn dirt can be removed with special cleaning agents for bikes and bike components. Pay attention to the notes and
recommendations for use printed on the respective cleaner.
In addition, you will find numerous cleaning and care products for your bike on www.rosebikes.com.
After having cleaned your bike, you must lubricate the chain (see "5.2.2 Chain maintenance" on page 48).
Pay attention to cleanliness in the area of your suspension fork's wipers. Dirt in this area may cause premature wear and
thus a loss of performance of your suspension fork.
Cleaning the battery
Never immerse the battery in water and never clean it with a jet of water. Only clean the battery with a soft, damp cloth.
X X
X X
X X
X X
X X
X X
X X
X X
47