Wiring Diagram - Royal Catering Rcam-220Pro Manuel D'utilisation

Then hold button (c) in the front and button (b) on the back of the sharpener simultaneously

for approx. 3-4 seconds to sharpen the knife and remove the burr. Release both buttons
simultaneously.
CAUTION!
Do not exceed the above-mentioned sharpening time of 3-4 seconds so as not to cause the

so-called "zero grind".
Stop the device and check whether the knife is sharpened enough. Continue until the desired

grind is reached.
WARNING! POSSIBLE CUTS DANGER! THE KNIFE IS VERY SHARP, SO WHEN CHECKING THE
GRIND, ONE MUST BE VERY CAUTIOUS. ALWAYS USE PROTECTIVE GLOVES!
After sharpening, clean the knife and the sharpener elements. In order to ensure it will

operate correctly, keep the sharpener in good condition.
Put the sharpener back to its initial position. Follow the installation instructions in reverse

order.
CAUTION!
Injury danger! Only start the device with the sharpener assembled correctly! The sharpener

is used as the knife cover in the upper part of the device.
In order to keep the knife in the optimum condition and maintain safety it should be

replaced, when its height is reduced by approx. 5-7 mm.
4.5.

Wiring diagram

EN
Figure 8: Wiring diagram of the product