Selecting The Input Signal - Sony CPJ-D500 Mode D'emploi

Projecting (continued)
Tips
• The projector
automatically selects
the same signal as the
last time. Therefore, if
you use the projector
with the same
equipment as the last
time, you do not need
to select the signal
again.
• The projector accepts
and automatically
selects either PAL or
NTSC color system.
Note
A part of the picture
may not be displayed
with some RGB signals.
14
Projecting
-EN

Selecting the input signal

Select the appropriate signal corresponding to the
connected equipment.
If you project the source from a PC, you further
need to select RGB mode according to your PC, IBM
PC/AT or Macintosh.
1
Input the signal to the projector.
When connected to the video equipment, start
playback.
2
Press PC/VIDEO to select the signal.
"PC/RGB" appears at the top left of the screen.
Each time you press the button, the PC or video
signal is selected alternately.
When you have selected VIDEO, the following
steps are not needed.
3
When projecting the source from the PC, press
FUNCTION until "PICTURE MODE" appears.
PICTURE MODE
MODE 1 MODE 2
4
Press + or – until the appropriate mode appears.
• IBM PC/AT and its compatible: MODE 1
• Macintosh and its compatible: MODE 2
The display will go off after 5 seconds.
PICTURE MODE
MODE 1 MODE 2