Fine Adjustment For Each Input Signal; Selecting The Input Signal; Fine Magnetic Focus And Aqp/Dqp Adjustments; Fine Registration Adjustment - Sony VPH-G90E Manuel D'installation

Fine Adjustment for Each Input Signal

Fine Adjustment for Each Input Signal

Selecting the Input Signal

Fine Magnetic Focus and AQP/DQP Adjustments

Fine Registration Adjustment

122
(GB) Adjustments
After the registration adjustment is performed without an input source and
the adjustment data is saved as the standard data, input an external signal
and fine adjust for each input signal.
1
Input an external signal.
Input the signal to the INPUT A connectors of the projector, the
VIDEO connectors of the IFB-G90E Video Interfrace Board, or the
signal interface board installed to the INPUT B or INPUT C section.
2
Select the video input source by pressing the INPUT SELECT keys on
the remote commander.
1
Press the PATTERN key to display the 9 × 9 DOT pattern.
2
If necessary, fine adjust the magnetic focus, AQP and DQP.
For details, see "1 Adjusting the green magnetic focus, AQP/DQP and AHP/
DHP" on page 87 .
(GB)
3
Press and release the MEMORY key to save the adjustment data.
Note
Do not hold down the MEMORY key in step 3.
1
Press the PATTERN key to display the CROSS HAIR pattern.
2
If necessary, fine adjust the registrations.
For details of the adjustment procedure, see "Adjusting the Registration" on
pages 93 to 120 .
(GB) (GB)
3
If two ore more input sources are connected, fine adjust the registration
for each input signal.
4
Press and release the MEMORY key to save the adjustment data.
Note
Do not hold down the MEMORY key in step 4.