Sony VPH-G90E Manuel D'installation page 23

7
Insert the two adjustment screws (gold) into the appropriate adjustment
holes corresponding to the screen size.
By default, the two adjustment screws (gold) are fixed to the two
adjustment holes for 120 inch screens.
For 90 and 300 inch screens other than 120 inch ones, remove the
adjustment screw from the 120 inch hole and insert it into the elliptic
hole for 90–300 inch screens. Then, loosen the other adjustment screw.
8
For screens other than 120 inch screens, move the red CRT right and
left so that the vertical line of the red cross hatch pattern converges
with the green pattern, then tighten the two adjustment screws (gold).
Caution
When moving the CRT, do not insert your hands into the small
opening between the lenses. Doing so may injure your hand.
9
Tighten the two red CRT fixing screws (black).
10
Repeat steps 6 to 9 to loosen the two blue CRT fixing screws (black),
adjust the blue CRT conversion angle and tighten the two adjustment
screws (gold).
Example: Red CRT
For 90–300 inch screens
S
Move.
L
120
For 120 inch screens (by default)
Installation
Loosen.
23
(GB)