Connecting Directly To The Projector - Sony VPH-G90E Manuel D'installation

Connecting Directly to the Projector

to video input
Color
monitor
*
IN OUT
TRIGGER LINK
VIDEO IN
to video output
Video equipment
to S video output
* For the VPH-G90E model:
IFB-G90E Video Interface Board (optional).
This is an example to connect pieces of video equipment directly to a
single projector.
Use the IFU-1271/1271M Signal Interface Unit.
Rear
VIDEO
OUT
IN OUT
IN OUT Y IN C IN
VIDEO S VIDEO
VIDEO
IN OUT
RS-232C/422A
RS-232C RS-422A
PLUG IN POWER
CONTROL S DEVICE INDEX
S VIDEO
IN
Setting up
• Set INPUT A in the SET SETTING 1 menu
• Select VIDEO or S VIDEO by pressing the INPUT SELECT keys on the
remote commander.
• Switch the 75-ohm terminate connectors on the BA board according to
the connections of the computer and color monitor.
For details, see "Switching the 75-ohm Terminate Connectors" on page 27
AC IN
AC power cord (supplied)
to a wall outlet
R G B SYNC/HD VD
R-Y/P Y B-Y/P
R B
INPUT A
IN PJ COM OUT
REMOTE
INPUT A
IFU-1271/1271M
Signal Interface Unit
IFB-12/12A
signal interface
board, etc.
Computer
to RGB output
to RGB input
to RGB input
to RGB output
Color
monitor
Signal flow
to RGB.
(page 62 )
(GB)
29
Connections
.
(GB)
(GB)