The Service Setting 3 Menu; Device Control - Sony VPH-G90E Manuel D'installation

Using the MENU
ALL WHITE MODE
Sets the duration of all white mode during a warm-up
period.
A L L W H I T E M O D E : 2 0 m i n
Use the V, v, B or b key to set the duration in 1
minute increments from 0 to 99 minutes.
To set the projector to display the picture immediately
after the projector is turned on, set the duration to "0
min."
PJ. COM (projector communication)
Sets the communication baud rate for the PJ. COM
terminal to 38.4 K, 19.2 K or 9600.
S I N P U T - A
D I R E C T P O W E R O N : O F F
SET
SETTING2
O N D E L A Y : O F F
A L L W H I T E M O D E :
INPUT
INFO.
2 0 m i n
P J C O M : 3 8 . 4 K
SET
INFO
R S - 2 3 2 C / 4 2 2 A : 3 8 . 4 K
SERVICE
SETTING1
SERVICE
SETTING2
SEL: SET: ENTER
EXIT: MENU
RS-232C/422A
Sets the communication baud rate for the RS-232C/
422A terminal to 38.4K, 19.2K or 9600.
S I N P U T - A
D I R E C T P O W E R O N : O F F
SET
SETTING2 O N D E L A Y : O F F
A L L W H I T E M O D E :
INPUT
INFO. 2 0 m i n
P J C O M : 3 8 . 4 K
SET
INFO R S - 2 3 2 C / 4 2 2 A : 3 8 . 4 K
SERVICE
SETTING1
SERVICE
SETTING2
SEL: SET: ENTER
EXIT: MENU
70
(GB) Before adjustment

The SERVICE SETTING 3 Menu

(Expert mode)
The SERVICE SETTING 3 is used for the adjustments
performed by the specialized service personnel only.
E
D E V I C E C O N T R O L
SERVICE
SETTING3
PIC
ORBITING
INT.OSC
SETTING
TIMER
UNI
FORMITY
SEL: SET: ENTER

DEVICE CONTROL

This item is used when the service personnel has
replaced the internal board. Do not use this item
normally.
I N P U T - A
EXIT: MENU