Sony VPH-G90E Manuel D'installation page 142

Setting the Index Numbers List of the Projection Distance by Angle of Optical Axis
To set the device index number
142
(GB) Others
4
Press the MENU key to exit the menu mode.
If you set the device index number, you can control each projector
individually with the supplied remote commander.
Set the device index number with the DEVICE INDEX switches on the
rear of the projector. Device index number "01" is set at the factory. Do
not change from "01" if the projector is used alone.
Ten's digit
Notes
• Do not set the same device index number on multiple projectors in the
same system.
• Do not set the device index number to "00." If you do, the projector
will be operated only with the keys on the control panel. It cannot be
controlled with the wired or wireless Remote Commander, or with an
external equipment via the PJ COM connector.
Notes on setting of the index number
• Set the same group index number for all equipment of the same
system connection (those on the signal route between the signal
source and the projector).
PC-3000
*
Signal flow
PC-3000
*
Signal flow
Projector
*
PC-3000
*
Signal flow
Projector
*
Signal flow
Projector
Unit's digit
0
Set the same group index number.
Set the different group index number
for two systems.
Set the same group index number.
* PJ COM IN/OUT connections